If the standard mesher is not good for your model switch to curvature-based. Once you identified a good mesh, you can easily switch to the second order.Īlso Standard mesher should be preferable in the first place because it has more predictable behavior and you won’t get additional nodes that you don’t need. Speaking about meshing, start always with a draft mesh to save time. Linear material model will give you an idea what to expect.The mesh can be transferred once you find the good balance between precision and speed.It’s quick to run to check contacts and boundary conditions.In addition, if you find it unstable you can again convert it in a Non-linear study and try to use the damping as a “stabilizer” for the run (check also my presentation at SWW 2018 about Rayleigh damping here. Later on, when you are ok with the setup, you can convert easily the linear study in a Non-linear one. Here there is an extract from my presentation at SWW Los Angeles in 2017 to enhance your workflow and have a smoother experience with Non-Linear module.įirst some advice about the use of the module: don’t go immediately with it but start with a Linear Static Analysis. When you are dealing with a Non-Linear Analysis inside SOLIDWORKS Simulation Premium sometimes is really hard to get the job done.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |